Formula and worked example
Volume = coverage area × layer depth. Rectangle coverage = length × width; circle coverage = π × diameter² ÷ 4. Repeated dimensions represent identical, non-overlapping areas. Known area is already the total and ignores the hidden repeat quantity. For different areas or deductions, use the Square Footage Calculator first. Divide cubic feet by 27 for cubic yards.
The example 12 × 9 ft area at 3 inches gives 27 ft³ = 1 yd³ = 0.764554857984 m³. The depth is illustrative, not a material specification. An optional 10% extra allowance gives 29.7 ft³. Extra volume is applied once: base × (1 + extra / 100).
Optional bulk-density weight
Weight = volume × matching bulk density. For example, a user-supplied 100 lb/ft³ gives 2,700 lb, or 1.35 US short tons, for 27 ft³. This density illustrates arithmetic and is not a recommended sand density. Alternatively, 10 m² at 100 mm gives 1 m³; at a supplied 1,600 kg/m³ it weighs 1,600 kg, or 1.6 metric tonnes. Extra 10% gives 1.1 m³ and 1,760 kg.
Use a measured or supplier-provided bulk density including voids and matching moisture and loose/placed condition. Particle density and specific gravity are different quantities. Sand moisture can change bulk volume and density. No universal dry, wet, bulking or compaction factor is prefilled or applied.
Delivery loads
Volume minimum = round up(total volume ÷ usable volume per load). With weight enabled, optionally calculate payload minimum = round up(total weight ÷ usable payload per load). Estimated loads = the larger minimum when both constraints are assessed. With 1 yd³ of sand, a 0.5 yd³ usable volume capacity requires 2 loads. At 100 lb/ft³ and a 1,000 lb usable payload, the payload minimum is 3, so the combined estimate is 3 loads. The final load can be partial.
Enter the carrier’s confirmed usable capacity and payload, accounting for its operating constraints. Gross vehicle weight is not payload. Volume-only estimates do not assess payload. The calculation assumes divisible bulk material and consistent capacities; it does not plan routing or packing. If your project dimensions describe placed sand, establish a matching loose delivery volume with your supplier before using truck capacity. No automatic conversion between material conditions occurs.
Units and validation
1 ft³ = 0.028316846592 m³; 1 yd³ = 27 ft³; 1 lb = 0.45359237 kg; 1 US short ton = 2,000 lb; 1 metric tonne = 1,000 kg. Length selectors convert measurements. Area, density and capacity selectors retain numeric entries. Use finite decimal inputs with positive dimensions and capacities, whole repeats from 1 to 10,000, and 0–100% extra volume. Supported bulk densities span 0.001–10,000 kg/m³ as an input sanity range, not a sand specification. Total volume is capped at 1 billion ft³ and load counts at 10 million.
Displayed volumes and weights use up to three decimals; whole loads round up using the full decimal entries and exact unit conversions. Circles use a numerical approximation to π. Supplier order increments, pricing, mortar/concrete mix proportions, material suitability and actual transport arrangements are outside this estimate.
References
NIST SP 811 conversion factors provides the unit basis. FAO: Farm structures, building materials and aggregate properties explains the distinction between bulk and particle density and the effect of moisture on sand volume. Example density and carrier capacities on this page are arithmetic scenarios supplied by the user, not values prescribed by these references.